The Sendhamarai Engineering is providing boom lift, which is part of the Aerial Elevated Work Site (AEWP) section, is very useful for accessing difficult locations for work such as maintenance, construction and emergency response. Boom lift operation requires proper training and recognition. Safety precautions to be taken to keep the boom lift function running smoothly. Here are some tips for working safely or around it.
First Be aware of your surroundings
Whether you remove the climb or work nearby, staff should pay attention to avoid accidents. Like driving a truck or car, you need to focus on what is going on around you to operate the tail lift. For example, if operating a boom lift near hydraulic lines, one should be aware of the lines and use extreme precautionary measures to avoid electrocution (in this case, a gap of 3 meters (10 feet) between the machine and the lines.
Second do not overload the lift
Most aerial platforms are equipped with overweight sensors and will not lift if you exceed the safety limit. If the sensor is not overweight, the terminal can overload the load platform. Small loads are desirable.
Third one is to make sure the tail lift is properly inspected
If you are authorized to inspect the machine, check that all parts are working properly and that the lift has sufficient power before using it. Also, check for leaks and treat accordingly. If the lift is not properly inspected, a malfunction can occur. All boom lifts have an emergency stop button; You never want to use this, but it can help prevent accidents caused by malfunctions.
Fourth is to Wear a saddle
To avoid falling off the platform, wear a saddle and secure it to the rails. The guard is designed to keep you on the platform, but in the event of high winds or elevator failure, wearing a saddle can save your life.
Fifth one do not use controls from the floor if someone else is operating the lift.
Always allow the occupant to have full control of the lift in the event of an emergency or if the occupant controls are not working. Attempting to use two different controls at the same time can cause the engine to malfunction or cause an accident.
Most Important – do not lean on the rails
Even if you are wearing a saddle, you may fall out of the basket if you are leaning or hanging on trains. If you can’t reach anything, adjust the lift position and height accordingly. This also means that you should not use ladders or any other material to increase height.Where sendhamarai engineering is providing all the intructions and precaution training to the customer while delivering the machine or else providing certified operators.
